Wiring annunciators in parallel.

This Forum is designed to support and assist in the use of any/all FDS related Interface products.

Moderators: Curtis, Jetcos

Post Reply
jimbo
Posts: 183
Joined: Mon Mar 29, 2004 3:49 pm
Location: Wexford Ireland

Wiring annunciators in parallel.

Post by jimbo »

Hi guys,

Making up wiring looms for my annunciators.Three wires coming from the PCB. Black is common and then two whites one for each LED. Is it possible for me to join the two whites to save on outputs?

Cuts down on wire aswell!

James
IBL Signiture Boeing 767 300 Builder.
Skype james.webster4

Jon Boe
Posts: 397
Joined: Mon Feb 16, 2004 5:46 pm
Location: Centennial, Colorado USA

Post by Jon Boe »

James,

The SYS board outputs support two LED's per port. You should be fine.

Jon

jimbo
Posts: 183
Joined: Mon Mar 29, 2004 3:49 pm
Location: Wexford Ireland

Post by jimbo »

Hi john, Thanks.

Saves on wire big time. 32 AN1s on the MIP as you know.

James
IBL Signiture Boeing 767 300 Builder.
Skype james.webster4

vidarf
Posts: 504
Joined: Fri May 12, 2006 11:37 am
Location: Narvik, Norway
Contact:

Post by vidarf »

Check this out:
http://www.fagerjord.org/cockpit/index. ... rfacing_oh

NOTE: Peter have a similar solution for ya....

Post Reply