Pressurization Rotary Encoders

This Forum is designed to support and assist in the use of any/all FDS related Interface products.

Moderators: Curtis, Jetcos

Post Reply
Paul M
Posts: 88
Joined: Wed Mar 28, 2007 12:46 pm
Location: KALB

Pressurization Rotary Encoders

Post by Paul M »

In a post dated 12/19/06 on Rotary Encoders it was stated

[/quote "All applications that we have run into that require Rotary are covered with our G1, G2, Plug and Play NAV/COMM." ]

So if only NAV/COMM are supported than does that mean that it is not possible to enable the pressurization panel Rotary Encoders and 7 segment LED's?
If it is possible how would that be accomplished?


Thanks,

Paul Moore
Albany, NY

bwr014
Posts: 1064
Joined: Wed Mar 10, 2004 4:39 pm
Location: Netherlands
Contact:

Post by bwr014 »

Hello Paul,

there is no seperate rotery encoder or 7 segment interface board at the moment. All those functions for the use of 7 segs and rotery encoders are already build in our G1/G2 and com/nav interface that is plug and play for the specifide functions.

Future will show what else will be available... right now sysboards for input and output, joystick axes, plug and play modules for nav/com and whole MCP/FCU units.

gr.

Frans M
frans@flightdecksolutions.com

Paul M
Posts: 88
Joined: Wed Mar 28, 2007 12:46 pm
Location: KALB

Post by Paul M »

Thanks Frans.
I do hope to get started with my project within the year. By the time I get there, FDS may have something or I will have to wait!

Thanks again
Paul M

Post Reply