Sys1 internal values

This Forum is designed to support and assist in the use of any/all FDS related Interface products.

Moderators: Curtis, Jetcos

Post Reply
Achilles
Posts: 7
Joined: Sun Apr 06, 2008 4:42 am

Sys1 internal values

Post by Achilles »

hello,

How can i make my own internal values and configure them?

Achilles

bwr014
Posts: 1064
Joined: Wed Mar 10, 2004 4:39 pm
Location: Netherlands
Contact:

Post by bwr014 »


Achilles
Posts: 7
Joined: Sun Apr 06, 2008 4:42 am

Post by Achilles »

bwr014 wrote:Like?

Gr.

Frans M
frans@flightdecksolutions.com
Hello,

Like output off when battery off. Because I use the sys board for the MIP and I have always the gear lights on when battery is off.

bwr014
Posts: 1064
Joined: Wed Mar 10, 2004 4:39 pm
Location: Netherlands
Contact:

Post by bwr014 »

This sounds more like a logic..

Not sure that is as offset available this is a standard setup of FS itself but maybe it is possible to check with the software you use for the logics outside FS..

gr.

Frans M
frans@flightdecksolutions.com

Achilles
Posts: 7
Joined: Sun Apr 06, 2008 4:42 am

Post by Achilles »

bwr014 wrote:This sounds more like a logic..

Not sure that is as offset available this is a standard setup of FS itself but maybe it is possible to check with the software you use for the logics outside FS..

gr.

Frans M
frans@flightdecksolutions.com
It can be done from pmsystems of cource like

if batt1 = 0 then
LandGearNose = 16382
LandGearLeft = 16382
LandGearRight = 16382
else
LandGearNose = fsgear
LandGearLeft = fsgear
LandGearRight = fsgear
endif

The offset for fsbattery is 3102 byte 1 value (1 = on, 0 = off)

So an internal variable for controlling the outputs (leds) according to fsbattery will be usefull.

bwr014
Posts: 1064
Joined: Wed Mar 10, 2004 4:39 pm
Location: Netherlands
Contact:

Post by bwr014 »

If you choose in interfaceIT under the led that controle this the option of making a FSUIPC ON/OFF ?

Fill in that offset, Byte, Value, 0 and then a similar one by the same led but then with value ,1

That doesnt work?

gr.

Frans M
frans@flightdecksolutions.com

Achilles
Posts: 7
Joined: Sun Apr 06, 2008 4:42 am

Post by Achilles »

bwr014 wrote:If you choose in interfaceIT under the led that controle this the option of making a FSUIPC ON/OFF ?

Fill in that offset, Byte, Value, 0 and then a similar one by the same led but then with value ,1

That doesnt work?

gr.

Frans M
frans@flightdecksolutions.com
nop. I tried this way but nothing.

Post Reply