RENP Rotary switch

This Forum is designed to support and assist in the use of any/all FDS related Interface products.

Moderators: Curtis, Jetcos

Post Reply
StephenJohnson
Posts: 7
Joined: Sun Jun 20, 2010 4:05 pm
Location: Spain

RENP Rotary switch

Post by StephenJohnson »

Hi,

I have wired up the RENP rotary switch as follows, holding the switch with the pins pointing out on the left.

pin1 Blue

pin2 Blue

pin2 Purple

The switch responds in locate mode after 3 nudges to the left or to the right. As the sys board only seems to understand OFF or ON, how do I program a different response depending on the direction the rotary switch is turned?

Also regarding the 3 pole switch which has the positions, Down - ON, Middle - OFF, Up - ON, is there a way to differentiate 3 different responses in the InterfaceIT program?

regards Steve

Post Reply