Flightdeck Solutions Forum Index Flightdeck Solutions
The place to meet and talk with fellow builders
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

RENP Rotary switch

 
Post new topic   Reply to topic    Flightdeck Solutions Forum Index -> FDS - Interface Products
View previous topic :: View next topic  
Author Message
StephenJohnson



Joined: 20 Jun 2010
Posts: 7
Location: Spain

PostPosted: Wed Nov 17, 2010 8:36 am    Post subject: RENP Rotary switch Reply with quote

Hi,

I have wired up the RENP rotary switch as follows, holding the switch with the pins pointing out on the left.

pin1 Blue

pin2 Blue

pin2 Purple

The switch responds in locate mode after 3 nudges to the left or to the right. As the sys board only seems to understand OFF or ON, how do I program a different response depending on the direction the rotary switch is turned?

Also regarding the 3 pole switch which has the positions, Down - ON, Middle - OFF, Up - ON, is there a way to differentiate 3 different responses in the InterfaceIT program?

regards Steve
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    Flightdeck Solutions Forum Index -> FDS - Interface Products All times are GMT - 5 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group