LED's for use with SYS boards (Resolved)

This Forum is designed to support and assist in the use of any/all FDS related Interface products.

Moderators: Curtis, Jetcos

Post Reply
ribel
Posts: 85
Joined: Tue Feb 24, 2004 2:40 pm
Location: EGNT

LED's for use with SYS boards (Resolved)

Post by ribel »

Do you specify/recommend an LED's characteristics for use with the SYS interface boards?

Would these be okay?

http://www.led-depot.co.uk/epages/es111 ... 20Clear%22

Sean

pcos
Site Admin
Posts: 2289
Joined: Mon Nov 03, 2003 8:39 am
Contact:

LED

Post by pcos »

These would be fine.
You do not neeed any resistors for LEDs with our SYS boards btw.
PC

ribel
Posts: 85
Joined: Tue Feb 24, 2004 2:40 pm
Location: EGNT

Post by ribel »

So anything in the range of 2V and 20mA?

Thanks PC

pcos
Site Admin
Posts: 2289
Joined: Mon Nov 03, 2003 8:39 am
Contact:

LEDs

Post by pcos »

Any standard Low voltage or Super Bright LED works fine.
I would not be concerned about this to be honest.
There are so many variables to watch for that a list or criteria would be tough to create.
Watch the brightness levels of the LEDs.. Keep them in range of each other.
Test if you feel the need..
PC

Wantolinez
Posts: 18
Joined: Tue Jun 19, 2007 7:34 pm
Location: Argentina

Post by Wantolinez »

I want to replace some leds that they do not seem to be so brigght and found some superbright at:

http://www.ebay.com/itm/180734798153?ss ... 1497.l2649

Would the Sys board support them?

Thanks.

pcos
Site Admin
Posts: 2289
Joined: Mon Nov 03, 2003 8:39 am
Contact:

LEDs

Post by pcos »

Absolutely.
Peter
____________________
Peter Cos
President
Flightdeck Solutions (FDS)

Post Reply