PMDG NGX and MCP G2 issue

This Forum is designed to support and assist in the use of any/all FDS related Interface products.

Moderators: Curtis, Jetcos

Post Reply
flyboy01
Posts: 89
Joined: Sat May 06, 2006 7:42 pm
Location: Newcastle Australia

PMDG NGX and MCP G2 issue

Post by flyboy01 »

Hi All,
Just wondering if anyone has had an issue with the old version of the MCP G2? I have just upgraded the sim from FS9 to FSX with the PMDG 737NGX. I have the following problem. All my project magenta software loads up ok, and i have removed the panels from the NGX. After i take off and then set the auto pilot, The auto pilot commands the plane to nose down and fly in to the deck. Not sure if this is offset issues programmed into the FDS G2 board or if there is some other underling issue. Any help much appreciated.

Cheers
Trev

Jetcos
Posts: 1276
Joined: Fri Sep 30, 2005 2:42 pm
Location: Newmarket,Ontario
Contact:

Post by Jetcos »

Can you try it with the Default aircraft? Does it work ok with the Default aircraft?
Steve Cos
Vice President and Tech Support
Flightdeck Solutions (FDS)

flyboy01
Posts: 89
Joined: Sat May 06, 2006 7:42 pm
Location: Newcastle Australia

Post by flyboy01 »

I will try this out over the next few days.
Thanks Steve

Trevor

neuman5022
Posts: 261
Joined: Fri Nov 25, 2005 9:15 pm
Location: Nelson NEW ZEALAND

Post by neuman5022 »

I have the G2 MCP, and working with the defualt 737 of FSX. Never had an issue with it.

Cheers

Isaac

flyboy01
Posts: 89
Joined: Sat May 06, 2006 7:42 pm
Location: Newcastle Australia

Post by flyboy01 »

cheers isaac it is probably the offsets to do with the ngx.

Post Reply