Flightdeck Solutions Forum Index Flightdeck Solutions
Technical Support Forum
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Programming in InterfaceIT

 
Post new topic   Reply to topic    Flightdeck Solutions Forum Index -> FDS - Interface Products
View previous topic :: View next topic  
Author Message
EnglishRebel



Joined: 19 Feb 2012
Posts: 18
Location: Lewisville, NC (WINT)

PostPosted: Sat Apr 27, 2013 7:57 am    Post subject: Programming in InterfaceIT Reply with quote

Is it possible to do any other programming in InterfaceIT other than just putting in Offsets? I have an APU panel that has two switches -- one switch has one LED and the other has two LEDs. One switch cannot be functional until the other switch has been pushed. So what I need to do is Inhibit the offset that one switch sends until a second offset has been sent.
The two LEDs in the one switch cannot be on at the same time. One needs to be on for 10 seconds and the second needs a 12 second delay before it comes on (so there is a 2 second gap between one LED turning off and the other turning on -- but that delay could also be zero).
So what needs to happen is to add a 12 second delay the first LEDs Offset and adding a duration that another LEDs Offset is active.
Hope that is clear. Very Happy
Thanks
Alan
_________________
Learjet 45
http://www.hangar45.net
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    Flightdeck Solutions Forum Index -> FDS - Interface Products All times are GMT - 5 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group