FDS-SYS-R1X

This Forum is designed to support and assist in the use of any/all FDS related Interface products.

Moderators: Curtis, Jetcos

Post Reply
baw028
Posts: 67
Joined: Thu Apr 20, 2006 12:07 pm
Location: UK

FDS-SYS-R1X

Post by baw028 »

I have 2 starter switches that have 5volt servo motors attached. Is it possible to use the FDS-SYS-R1X board to operate these. Is it just a case of using the SIM A software to active these motors?

Thanks for any help
Roger

Jetcos
Posts: 1273
Joined: Fri Sep 30, 2005 2:42 pm
Location: Newmarket,Ontario
Contact:

Post by Jetcos »

You can wire the switches inputs to the SYS1. If you have real Cole switches you will need a Relay card. Assigning the output to the relay card. Are those the switches you have?

The SYS card is not made to trigger any 5 V solenoid.
Steve Cos
Vice President and Tech Support
Flightdeck Solutions (FDS)

Post Reply