Rotaries and Knobs

Dedicated to The Support of All Flightdeck Solutions, Ltd Products

Moderators: Curtis, Jetcos

Post Reply
lestat
Posts: 26
Joined: Sat Nov 08, 2003 11:34 am
Location: Austin, Texas

Rotaries and Knobs

Post by lestat »

I am finally getting to add some electronics!!! Now I am a little stuck on the Knobs/Rotaries issue. Does anyone know if the rotaries/knobs all work together? Are there certain knobs that match the size for different rotaries (selector/encoder)?
It would seem that the Round Knobs are for the Encoders and the others match the selectors?
As for the dual concentric I am sure there is some special knob needed (or perhaps someway to use 2 knobs by drilling a hole through one of them? Any ideas/information on this would help. Any ideas on the size of the knobs would be helpful as small would be good on the Audio panel while larger is good for the CRT selection panel, etc. all.

Thanks for any/all information
--Russ

Post Reply