737 MCP strange behaviour

This Forum is designed to support and assist in the use of any/all FDS related Interface products.

Moderators: Curtis, Jetcos

Post Reply
GDR
Posts: 337
Joined: Fri Sep 26, 2008 3:16 am
Location: EBBR
Contact:

737 MCP strange behaviour

Post by GDR »

Hi,

When performing a flight, I regularly have the MCP together with the EFIS panels going dark. These are interfaced via the SYSBoard controller of SIM-A. When checking the controller the components are still listed (as active). Restarting the complete sim (all computers and software) resolves this, till I start a flight. It even happened whilst programming the flight plan.

The happens whilst (OR) push back, taxi, take-off, during flight, ... So, randomly. Strange...

I do have sometimes the luck that I can complete the flight without issues. All other components function normally.

I did check the USB wiring, power (both 5V and 12V ; connected to dedicated power supply capable of pulling 6A each). All looks fine here.

What else could I check to see what's causing this issue?

Thx. :wink:
Geert.

Full B737-MAX DSTD - ALL FDS
Sim-Avionics V1.965
P3D v4.5.13.32097
FSUIPC v5.154

What goes up, must eventually come down!
http://www.flightsim737.be
http://www.flightsim737max.be
http://www.flightsim737ng.be

Post Reply